Product introduction 產品簡介
This product is the third generation of high-performance water reducer,which is currently high-efficiency water-reducing agent with the highest scientific and technological content, the best application prospect and the best comprehensive performance in the world.
It has the advantages of low dosage,high water reducing rate,good cement adaptability,small slump loss and strong durability,etc. It is a non-toxic, non-corrosive, non-combustible safe high-performance water-reducing agent.
Compared with the performance of similar products abroad, XNHPWA-800 high-performance water reducing agent has reached the current international advanced level in terms of technical performance indicators and cost performance.
本產品是第三代高性能減水劑,是目前世界上科技含量最高、應用前景最好、綜合性能最優的一種高效減水劑。具有摻量低、減水率高、水泥適應性好、坍落度損失小、耐久性強等優點,是一種無毒、無腐蝕、不燃燒的安全環保型高性能減水劑。與國內外同類產品性能比較,XNHPWA-800高性能減水劑在技術性能指標、性價比方面都達到了當今國際先進水平。
Main performance 主要性能
Project | Performance | |
Water reduction rate 減水率(%) | ≥25 | |
Bleeding rate ratio 泌水率比(%) | ≤70 | |
Solid content 含固量(%) | ≥15.0 | |
Air content 含氣量(%) | ≤6.0 | |
Density 密度(g/cm3) | 1.04±0.02 | |
Total alkali 總堿量(%) | ≤10 | |
Chloride ion content 氯離子含量(%) | ≤0.1 | |
PH value PH值 | 6.0±2.0 | |
Difference in solidification time 凝結時間之差(min) | Initial solidification 初凝 | >+90 |
Final solidifica 終凝 | — | |
1h change over time 1h經時變化量 | Slump 坍落度(min) | ≤60 |
Air content 含氣量(%) | — | |
Compressive strength ratio 抗壓強度比(%) | 1d | — |
3d | — | |
7d | ≥140 | |
28d | ≥130 | |
Shrinkage ratio 收縮率比(%) | 28d | ≤110 |
Relative durability9(200 times) 相對耐久性(200次)(%) | — |
Scope of application 適用范圍
This product is suitable for the preparation of various high-performance concretes such as precast concrete, self-leveling concrete, concrete with high water reduction and low water-cement ratio, and durable concrete.
本產品適用于配制各種預制混凝土、自流平混凝土、高減水低水灰比混凝土、耐久性混凝土等高性能混凝土。
Precautions for use 使用注意事項
1、The content of this product (solid content 20%) is 0.6% to 2.0% of the total weight of the cementitious material. The usual dosage is 0.8%~1.5%. Before use, a trial mix test of concrete should be carried out to find the best mixing amount.
本產品的摻量為膠凝材料總重量的0.6%—2.0%。常用摻量為0.8%—1.5%。使用前應進行混凝土試配試驗,以求最佳摻量。
2、This product should not be mixed with other water reducing agents. Before using this product, the storage tanks, mixers and mixer trucks that have used other water reducing agents must be rinsed, otherwise the water reducing effect may be affected.
本產品不得與其它減水劑混合使用。使用本產品之前必須將使用過其它減水劑的儲罐、攪拌機和攪拌車沖洗干凈,否則有可能會影響減水效果。
3、When using this product, the measurement must be accurate and the concrete must be mixed evenly.
使用本產品時,必須計量準確,混凝土必須攪拌均勻。
4、Because the water reduction rate of concrete mixed with XNHPWA-800 polycarboxylic acid high-performance water-reducing agent is relatively large, the slump is highly sensitive to water consumption, and water consumption must be strictly controlled during use.
由于摻用XNHPWA-800聚羧酸高性能減水劑混凝土的減水率較大,因此坍落度對用水量的敏感性較高,使用時必須嚴格控制用水量。
Packaging and storage 包裝與貯存
1、This product is liquid and is packed in 1000kg plastic drums or plastic bags.
本產品為液體,采用1000kg塑料桶裝或200±1kg塑料桶包裝。
2、Should be placed in a cool, dry place, sealed storage away from direct sunlight, rain or negative temperature environment preservation.
應置于陰涼、干燥處儲存,避免陽光直射、雨淋或負溫環境保存。
3、The warranty period is one year, and the overdue products can only be used after being tested and verified.
質保期一年,超期產品經試驗驗證合格后仍可繼續使用。